|
|

Monday, February 23, 2004
submitted by
Barkon Monday, February 23, 2004 at 12:18:37
---------------------------------------------------------------------------
Drew up an early camp layout based on Phil's headcount/arrivals document.
---------------------------------------------------------------------------
12:22 PM
Saturday, February 07, 2004
Below is the result of your feedback form. It was submitted by
Bark () on Saturday, February 7, 2004 at 08:24:45
---------------------------------------------------------------------------
Comments: Regarding Fimo clay, I have been researching conveyor ovens with electric conveyors and gas cooking heat. They're a bit large and costly to boot (can sell for over $1000) I posted the specs for one at the bottom of this message.
Smaller conveyor systems, tabletop cookers, exist but are 240V (both conveor and cooking heat are electric)- A possibility only if one of these could be hooked up with gas cooking heat.
Information on the Fimo firing requirements is here:
http://www.jaedworks.com/clayspot/polyclay-faq/firing.html
15-20 minutes at between 200-300 degrees, the lower the heat the better to prevent scorching.
The specs are as follows: It is a model #1116 later converted to lp gas and model #1117. 120 VAC/VCA 60HZ 7.0 AMPERES, SINGLE PHASE/MONOPHASE, TYPE OF GAS: NAT <---CROSSED OUT AND LP GAS WRITTEN IN, MIN10,000 BTU/HR MAX 40,000 BUT/HR, APPLIANCE MANIFOLD PRESSURE: 3.5 IN, MAX/MIN INLET PRESSURE 14/11 IN W.C., BURNER ORIFICE: .073 IN., BYPASS ORIFICE: .037 IN., MAN. PRESSURE: 10 IN . W.C., INPUT RATING: 40,000 BTU, CONVERSION KIT 369874 WAS INSTALLED BY ARROWHEAD GAS 5/7/01
x: 113
y: 8
---------------------------------------------------------------------------
8:25 AM
|